Controlled-products-systems-group 1506-080 Manuel d'utilisateur Page 1

Models 1506 and 1504 Programmable Stand Alone Digital Keypad Entry Devices Owner’s Manual P/N 1506-065 REV C, 9/01 Copyright 2001 DoorKing, Inc.

Page 10 1.3 Wiring Diagram 6 234512 11 110 9 8 714 13GNDMasterCodeONOFFElectric StrikeMagnetic LockPower16 VAC, 20 VAKeypad PowerPushto ExitTimeZone 2

Page 11 1.4 Circuit Board Terminal Identification 1. REQUEST TO EXIT – A switch closure to terminal 12 will activate relay 1 for its programmed str

Page 12 1.5 Model 1504 Aiphone Intercom Station Connections These wire diagrams are provided for convenience only. For detailed wiring information o

Page 13 1.6 Slave Keypad Wiring • Refer to Slave Keypad Instruction Sheet (p/n 1506-066) for instructions on mounting the 1599-010 board onto the

Page 14

Page 15 Keep a record of the programmed codes by completing the tables on pages 24 and 25. 2.1 Master Code The Master Code is a four-digit number th

Page 16 2.4 Programming Four-digit Entry Codes 1. Press *02 and enter the four-digit master code _ _ _ _ (short beep). 2. Enter the four-digit cod

Page 17 2.8 Programming Five-digit Entry Codes 1. Press *09 and enter the four-digit master code _ _ _ _ (short beep). 2. Enter the five-digit code

Page 18 2.12 Hold Boundary Programming The entry system hold boundaries establish a set of four-digit entry codes that will latch relay 1 ON, relay 2

Page 19 3.1 Four-digit Entry Codes To use a four-digit entry code, the # key must first be pressed then the four-digit code entered on the keypad. Fo

Page 2

Page 20 3.5 Hold Feature Operation The relay hold feature allows a set of four-digit entry codes to latch (or hold) a relay indefinitely. Any four-di

Page 21 3.6 Time Zone Operation The entry system has two time zone inputs. By using an external timer or switch, access can be denied to a group of f

Page 22

Page 23 4.1 Troubleshooting • Have a good VOM meter to use when checking voltages and continuity. • Check power wiring wire size and distance. Imp

Page 24 4.2 Data Tables Use the tables below to record data entered into the keypad system. MASTER CODE 4-DIGIT HOLD BOUNDARIES LOWER UPPER

Page 25 NAME 4-DIGIT CODE NAME 4-DIGIT CODE

Page 3 Use this manual with the following models 1506-080, 1506-081, 1506-082, 1506-083, 1506-084, 1506-085, 1506-086, 1506-090, 1506-091, 1506-092,

Page 4

Page 5 Table of Contents IMPORTANT NOTICES...

Page 6 2.15 • Prior to starting the installation, become familiar with the instructions, illustrations and wiring diagrams in this manual. • Neve

Page 7 1.1 Mounting Surface mount units can be mounted directly to a wall or pilaster, or they can be mounted using a gooseneck mounting post (p/n 12

Page 8 The flush mount keypad consist of two parts, the keypad and the rough-in box. Mount the rough-in box and wiring first, and then install the ke

Page 9 1.2 Wiring The wiring of this device is an extremely important and integral part of the access control system. It is very important that prope