Controlled-products-systems-group SLIDESMART DC 10F Manuel d'utilisateur télécharger pdf (Page 40)

Installing the Earth Ground

2-2 SlideSmart DC Installation and Reference Manual Revision D

Take the following steps to comply with NEC and NFPA

780 standards:

1. Install a grounding rod per local building codes. See

Figure 2-1.

2. Attach a large earth ground wire (6AWG) from the

grounding rod to the lug nut on the base of the chassis.

• New site: Run the 6AWG wire through the concrete

base and into the cutout on the chassis base.

• Existing site: Run the 6AWG wire beneath the rear

cover.

Properly grounding the gate operator is critical to gate

operator performance and the life of its electrical

components. Use sufficient wire size during installation.

Refer toWiring 115VAC Power or Wiring 208/230VAC

Power.

Consult

local

codes for

3 ft

Figure 2-1.

proper

depth.

Lug nut

Ground wire

and lug nut

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 147 148

Pas de commentaire

Controlled-products-systems-group SLIDESMART DC 10F Manuel d'utilisateur Page 40