Controlled-products-systems-group 212ILW Manuel d'utilisateur télécharger pdf (Page 12)

212iLW/242iLW Standalone Keypad

Installation/Programming Manual

Document # 6050700, Rev. 1.1, D2d

5.6 Wiring an Accessory Relay Board

(242 Only)

The accessory relay board contains physical outputs 2, 3, and 4

shown in the table below.

Physical Output Relay Connector

2 K2 P1

3 K3 P2

4 K4 P3

Use the wire harnesses supplied with the relay board to connect to

the relays. The wire colors are shown in the table below.

Wire Color Relay Connection

Gray Normally Closed

Blue Common

Green Normally Open

5.7 Wiring an Integrated Access Control System Using

the Accessory Relay Board

Physical outputs 2, 3, and 4 are defaulted to the alarm shunt, propped

door, and forced door virtual outputs, respectively. Use the following

steps to wire the alarm shunt, propped door alarm, and forced door

alarm.

Figure 9 Wiring the Accessory Relay Board

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Pas de commentaire

Controlled-products-systems-group 212ILW Manuel d'utilisateur Page 12