Controlled-products-systems-group 212ILW Manuel d'utilisateur télécharger pdf (Page 26)

212iLW/242iLW Standalone Keypad

Installation/Programming Manual

Document # 6050700, Rev. 1.1, D2d

9. Wire Harness Loopback

Connections

If the Master Code is either not working or forgotten, power down the

system, connect the wire harness as shown in Figure 12 below, and

then power the system up again. The unit should now be in program

mode. Next, change your Master Code using the programming

command and power down the system and restore the wire harness

to its original configuration and power the system back up.

Figure 12 Program Mode Loopback

1 2 ... 21 22 23 24 25 26 27 28

Pas de commentaire

Controlled-products-systems-group 212ILW Manuel d'utilisateur Page 26